Finishing Elitron Elitron Kombo SDC

Elitron Kombo SDC

 
Conveyor System
The conveyor bed version of the Elitron Kombo SD, the SDC comprises a conveyor and roll feed. The carriage vacuum and conveyor grip the media, initiates the cutting process and moves the media along to a rewind unit.

This same conveyor can also be used to cut rigid media longer than the bed by cutting in a series of steps each the length of the cutting bed, seamlessly and automatically.

A separate conveyor bed extension can be provided to move the processed material away from the work surface clearing it for the next job automatically.

CNC cutting system with management software developed under Windows operating system.
Conveyor working area 3100 x 2000 mm.

The working area is equipped with a highly efficient 7.5 KW vacuum table divided into 40 sectors and automatically activated by computer control and is equipped with clamping system to ensure the correct feed of roll materials on the conveyor and with a multi-tool cutting head to cut materials up to 120 mm. 50mm is standard with 120mm height as an option.

The tools carriage is equipped with: electric oscillating knife cutting module. A pneumatic module; circular knife tool; laser pointer tool for sheet position references can also be added.


Suction Surface.

The working area is equipped with a powerful 40 section vacuum system that allows to focus t
he power only where it's needed. No blanking off, no excess noise.
 
Automatic Nesting
Elitron Sofware can automatically arrange the images for a given size of sheet, or detected by the Seeker Pro and make the most economical use of the materials on the bed.

Projection System
Maximises the yield from your materials by projecting images onto the media beneath. The operator can then seee exactly how to plan the use of leftovers, half sheets etc. The material can then be used accordingly. For instance we know of an Elitron customer who uses left over PVC for interior van linings for a van hire company and can project the profile of each component of the lining onto the sheets, arrange them to suit and then cut them out without moving them from their arrangement. Simple and profitable

Virtual Die Projection System: 
 
The ultimate in operational simplicity adopted by Elitron in all its cutting systems with “virtual dies”. the operator uses a simple and effective projection system to easily position the shapes to be cut directly on the material, even on small leftovers or scraps, optimising the performance and thus reducing wastage.  Nesting can be done automatically or manually by the operator, using the mouse.

Elitron's software is very intuitive and allows the operator to run a simulation or pre-flight of the proposed cut, here they can see any over or under cuts or in the case of routing, ensure they are using the correct diameter bit.

Seeker System
The Seeker System comes in two versions, Standard and Pro.

The Standard version is fitted to the all the Kombo Range and sees the reference points on the sheet, locates the reference points for the images but does not load the cutting profiles.

The Seeker Professional version (option) does this too but also looks at each image individually allowing for distortion caused by the overhead camera position then loads the profile and cutting information for each image. So with the Pro you could put, Forex, banner, Dibond all together on the bed and the images would be recognised, the correct cutting profile loaded, the correct tools chosen for each job and the Kombo would then automatically proceed with the cutting.