Finishing Elitron Elitron Kombo SD

Elitron Kombo SD

The most advanced and productive cutter we've ever seen! Everything else seems prehistoric by comparison.

The Elitron SD is a class leading, innovative, industrial built cutting system. The standard maximum cutting thickness is 20mm although this can be increased to 50 or 120mm as options.

Weighing just over 2 tonnes it's built to last and give years of uninterrupted service, the bed will never need to be releveled there are no drive belts to replace. Both the beam and head carriage are rack driven, this leads to a higher speed and a more precise cut.
As standard the SD is equipped with a 1.2 Kw router, but there is also the option of a 3Kw version, with a water cooled head and built-in chiller, which is ideal for routing a lot of thick or hard materials.

The SD+ is the same overall specification but has bigger motors and braking to give better acceleration and stopping so providing faster cutting.

Virtual Die Projection System:  
The ultimate in operational simplicity adopted by Elitron in all its cutting systems with “virtual dies”. the operator uses a simple and effective projection system to easily position the shapes to be cut directly on the material, even on small leftovers or scraps, optimising the performance and thus reducing wastage.  Nesting can be done automatically or manually by the operator, using the mouse.

Elitron's software is very intuitive and allows the operator to run a simulation or pre-flight of the proposed cut, here they can see any over or under cuts or in the case of routing, ensure they are using the correct diameter bit. 
The multi tool head with auto tool change as an option, contains a marker pen, laser marker, standard camera, router, oscillating tool, drag knife, other tools include a kiss cutting knife, 45 degree knife for reboard, creasing wheel set and a rotating wheel for textiles

Available in three bed sizes;
1600 x 1200mm
2000 x 1600mm
3100 x 2000mm


A roll -roll system can be fitted. This option comes in various grades depending on the material and duty it's expected to perform. Please see Kombo SDC for more details

Suction Surface.

The working area is equipped with a powerful multi sectioned vacuum system that allows to focus the power only where it's needed. No blanking off, no excess noise.

Seeker System
The Seeker System comes in two versions, Standard and Pro.

The Standard version is fitted to the all the Kombo Range and sees the reference points on the sheet, locates the reference points for the images but does not load the cutting profiles.

The Seeker Professional option does this too but also looks at each image individually then loads the profile and cutting information for each image. So with the Pro you could put, Forex, banner, Dibond all together on the bed and the images would be recognised, the correct cutting profile loaded, the correct tools chosen for each job and the Kombo would then automatically proceed with the cutting.

Automatic Nesting
Elitron Sofware can automatically arrange the images for a given size of sheet or have been detected by the Seeker Pro and make the most economical use of the materials on the bed.

Projection System
This option maximises the yield from your materials by projecting images onto the media beneath. The operator can then see exactly how to plan the use of leftovers, half sheets etc. The material can then be used accordingly.


The Kombo SD+ can finish printed images on a range of materials such as Forex, Dibond, SAV, paper, card, corrugated, double wall, even PE or foam. Standard head height is 50mm but can be ordered with an option to take the head height to 120mm

The Kombo can be fitted with a range of tools such as, oscillating knife, electric or pneumatic, creasing wheels and a range of routing / milling tools. The system has a pre setting function for automatic set up

                                                                                                                               Multi tool head